CS-350WES
39
CLUTCH SYSTEM
5-2 Replacing clutch parts
1. Install tension spring (C) to the clutch shoes (B).
2. Set one arm of the clutch hub (A) to one guide of
the clutch shoe.
3. Install other two guides of the clutch shoes on
two arms as shown.
(A)
(A)
(D)
(D)
(C)
(B)
(C)
(E)
5-3 Installing clutch assembly
1. Insert washer (A) on crankshaft (Press fitting).
2. Apply lithium-based grease to needle bearing (B)
and install the needle bearing and clutch drum (C)
on crankshaft.
3. Install clutch plate (D) and clutch assembly to the
crankshaft turning it counterclockwise manually.
NOTE: Chamfered corner (E) of clutch plate (D)
should face inside.
4. Holding flywheel using flexible wrench, turn clutch
assembly counterclockwise using clutch tool
X640-000011.
To Next Page
Loading...
