Echo GT-1100

OPERATION
SAFE STARTING TECHNIQUES
NOTE: Always dear work area of debris before starting
operation.
NOTE: Always hold the unit firmly.
NOTE: When pulling starting rope, use short pulls. 1/2
to 2/3 of rope length.
NOTE: Do not allow the starter handle to snap back
against the housing.
NOTE: Always hold the unit firmly
STARTING COLD ENGINE
A DANGER: When engine starts, cutter head may
rotate, even with trigger in low speed position.
1. Turn ignition switch to START/RUN.
NOTE: The ignition switch on the G.T. 1100 is located
next to the carburetor.
3. Depress throttle trigger lully.
4 Pull starter handle several times until engine tires
once.