99944200475 OPERATION
© 4/2015 ECHO Inc.
X7702093705 13
OPERATION
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts
have come to a completestop before removing obstructions, clearing debris, or servicing unit. Allow
unit to cool before performing service.
Edger Operation Techniques
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause
unconsciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit
so that exhaust is directed away from your face and body.
1. Before edging, water the area to soften the ground to make
edging easier.
2. Before edging, check the area and remove all obstacles and
objects that could be thrown.
3. Plan to edge regularly to make it easier to keep a neat edge
and to avoid having to make more than one pass.
Note: Blade depth may have to be adjusted due to differences
in height between the hard surface and the top of the
grass.
Never adjust blade height with engine running, otherwise serious personal injury may result.
4. Loosen adjustment knob and adjust the blade's depth of cut
to produce a fine cut between sidewalk and grass using a
minimum blade depth, usually with about 13 mm (1/2 in.) of
the blade into the ground. Tighten adjustment knob.
5. Before edging, plan your direction of travel so that the unit
will always be positioned on your right side and so that you
walk on a hard surface whenever possible.
6. Hold edger as shown.
Before edging, be sure to read and understand the entire
Operator's Manual to avoid serious injury.
To Next Page
Loading...
Need help?
General