Echo PB-580 H/T User Manual

PB-580 H/T OPERATION
X7505200600 21
© 11/2014 ECHO Inc.
5. Choke
After engine fires (or 5 pulls), move choke lever back to RUN
( ) position, then pull starter handle/rope until engine starts
and runs. Allow unit to warm up at idle for several minutes.
Note: If engine does not start with choke in “RUN” position after
5 pulls, move choke to COLD START ( ) position, and
repeat steps 3- 5.
6. Throttle Lever
Allow engine to warm up for several minutes before use.
7. Throttle Lever
After engine warm-up, move throttle lever gradually to increase engine RPM to desired operating speed.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO
NOT close the choke.
1. Throttle Lever
Move throttle position lever (A) to IDLE position.
2. Purge Bulb
Pump purge bulb (C) until fuel is visible. Pump bulb an
additional 4 or 5 times.
3. Recoil Starter
Pull recoil starter handle (D) and engine should start. Do not
use choke (B)
Note: If engine does not start after 5 pulls, use cold start
procedures.
Stopping Engine
- PB-580 H
1. Throttle Lever
Move throttle lever (A) to IDLE position and allow engine to
return to idle before shutting off engine.
2. Throttle Lever
Move throttle lever (A) to “
O“ (STOP) position.
- PB-580 T
1. Throttle Lever
Release throttle trigger. Move Throttle Lever (A) forward to idle position and allow engine to return to idle
before shutting off engine.
B
C
D
PB-580 H
PB-580 T
A
B
C
D
PB-580 H
PB-580 T
A

Echo PB-580 H/T Specifications

General

Brand	Echo
Model	PB-580 H/T
Category	Blower
Language	English