20
startIng cold engIne
WARNING
The attachment will operate immediately when the engine starts,
and could result in possible serious injury. Keep movable parts of
the attachment away from objects that could become entangled or
thrown, and surfaces that could cause loss of control.
1. Stop Switch
Move stop switch button (A) forward away from the STOP
position.
2. Choke
Move choke (B) to “Cold Start” ( ) Position.
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and ows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Recoil Starter
Lay the unit on a at, area and keep movable attachment parts
clear of all obstacles. Firmly grasp right hand grip and throttle
trigger lockout with left hand and fully depress throttle trigger to
wide open position. Rapidly pull recoil starter handle/rope (D)
until engine res (or maximum ve [5] pulls).
5. Choke
After engine res (or ve [5] pulls), move choke lever back to
“Run” ( ) position. Hold throttle trigger and throttle trigger
lockout fully depressed and pull recoil starter handle/rope until
engine starts and runs. Release throttle trigger and allow unit to
warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions 2 - 5.
6. After engine warms up, gradually depress throttle trigger to in-
crease engine RPM to operating speed.
C
B
d
D
A
A
PPT-266
PPT-266H/S
PPT-266
PPT-266H/S
To Next Page
Loading...
Need help?
General