20
Maintenance and care
Maintenance and care
Servicing guidelines
Maintenance and care
Cleaning air filter
1. Close choke. Loosen screw and remove air cleaner cover
(A).
2. Remove air filter (B) (air filter is located inside air cleaner
cover).
3. Brush dirt from filter or clean with compressed air.
4. Reinstall filter.
5. Reinstall cover and tighten screw.
WARNING
Observe the following precautions when checking and maintaining your product after use:
Turn the engine off and do not attempt to check or maintain the product until the engine has cooled.
You could burn yourself.
Remove the spark plug cap before performing checks and maintenance.
An accident could occur if the product starts unexpectedly.
IMPORTANT
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
Area Maintenance Page Before use Monthly
Air filter Clean/Replace 20 •
Fuel filter Inspect/Clean/Replace 21 •
Spark plug Inspect/Clean/Adjust/Replace 22 •
Carburettor Adjust/Replace and adjust 21 •
Cooling system Inspect/Clean 21 •
Silencer Inspect/Tighten 22 •
Silencer Clean 22 •***
Flexible shaft Grease 22 •*
Angle transmission Grease 23 •**
Starter Inspect - •
Cut off knife Inspect/Clean - •
Fuel system Inspect 21 •
Screws, bolts and nuts Inspect, Tighten/Replace - •
* Or 18 hours, whichever occurs first. ** Or 50 hours, whichever occurs first. *** Or 100 hours, whichever occurs first.
IMPORTANT
Time intervals are maximum. Actual use and your experience will determine the frequency of required maintenance.
If you have any questions or problems, please contact your dealer.
To Next Page
Loading...
