ENGLISH
• NEVER use unit within 15 meters (50 feet)
of any power lines or wires that may be
conducting electricity. Contact with wires
carrying electrical current can result in shock
or electrocution.
• NEVER exceed the cutting capacity of the
hedge clippers - forcing the blades to cut
materials thicker than the hedge clipper is
designed to handle will result in jams, blade
damage, and poor overall performance.
• ALWAYS use a suitable tool such as a power
pruner or chain saw to cut branches larger than the hedge clipper will allow.
• NEVER attempt to cut more than 6 inches from a hedge or shrub in one
cutting pass. Use multiple passes for cleaner, safer cuts, and better control.
• ALWAYS stop engine and disconnect spark plug lead before removing a
blade obstruction.
• NEVER use dull, loose, or damaged blades. Keep blades properly adjusted
and lubricated at all times.
• NEVER adjust blades when engine is running. Shut engine off, and
disconnect spark plug lead from spark plug.
• ALWAYS use correct tools to perform blade adjustments. Use long
wrenches to keep hands away from sharp blade edges.
• ALWAYS place blade cover on blades when
transporting or storing unit.
PAS HCA ARTICULATING HEDGE CLIPPER
ATTACHMENT
DANGER
Metal blades are very sharp and can cause severe injuries, even if
engine is off and blades are not moving. Avoid contact with blades.
Wear gloves to protect hands.
• ALWAYS read, understand, and obey all hedge
clipper warnings, safety rules, and operating
instructions before using unit.
• ALWAYS shut unit off and make all cutting angle
adjustments on the ground.
Blade Cover
50 FT
15M
50 FT
15M
39
OPER ATION
To Next Page
Loading...
Need help?
General
