Why is the drive belt squealing or smoking on my Echo Trimmer?
If the drive belt on your Echo Trimmer is squealing or smoking, it could be because: * The drive belt is loose or worn, in which case you should replace it. * The pulley may be worn or damaged, requiring replacement.
What to do if my Echo WT160S requires excessive power or stalls?
If your Echo Trimmer requires excessive power or stalls, consider these potential causes: * The cutting string might be too long; reduce its length. * A loose or worn drive belt can cause issues, so replace it. * If the growth is too thick or heavy, reduce the trimming area or raise the trimmer head slightly off the ground. * A belt that is too tight can also be a problem; move the spindle hub assembly towards the rear of the trimmer.
Why is the cutting slow or rough on my Echo WT160S Trimmer?
If the cutting action of your Echo Trimmer is slow or rough, it could be due to several reasons: * The cutting string may be too weak; replace it with a heavier cutting string (.155). * If the growth is too thick or heavy, reduce the trimming area by half or raise the trimmer head off the ground. * The engine may not be running at full RPM, so speed up the engine to full throttle.
What to do if the trimmer disk does not turn on my Echo Trimmer?
If the trimmer disk on your Echo Trimmer does not turn, the possible causes are: * Broken off or damaged belts: replace belts. * Broken spindle: repair spindle. * Failed bearings: repair bearings.
What causes the drive chain to fall off self-propelled Echo WT160S models?
If the drive chain is falling off on your self-propelled Echo Trimmer, here's what might be happening: * The chain may be loose; tighten it. * The chain could be worn; replace it. * The sprocket may be worn; replace it. * The sprocket might not be aligned; align the drive sprocket and wheel clutch assembly with washers.
How to fix drive belt rolling or falling off pulleys on Echo WT160S?
If the drive belt on your Echo Trimmer is rolling or falling off the pulleys, it could be due to: * Pulley misalignment: Align the pulleys. * Improper belt tension: Tension the belt with 70 lbs of force. * Spindle bearing failure: Replace the bearing.
General| Engine Type | 2-Stroke |
|---|---|
| Cutting Width | 40 cm |
| Fuel Tank Capacity | 400 ml |
| Shaft Type | Straight shaft |
| Starter System | Recoil |
To Next Page
