A. Receiver and TV set-up
Check the Installation
To get the most out of the EchoStar DSB-1100 Viaccess it should be correctly installed, the dish should be
optimally aligned and the mechanical limit switched on the dish should be set properly. Press /I on the
remote control unit (RCU) or press on the front panel of the EchoStar DSB-1100 Viaccess.
5. Operation and Menu Program
8
The receiver is supplied with factory setting and will start up with the “Language Setting” menu. For more
information on the “Language Setting” menu, please see page 9. Please follow the steps outlined below to
properly install the EchoStar DSB-1100 Viaccess.
LNB Setting
Select the LNB type which conforms to your LN
B using the , keys.
Other parameter values should be changed
manually according to your LNB type.
Press the OK key to confirm your selection.
Select the “LNB Setting” menu in the “Installation” m
enu using the , keys.
LNB Setting
LNB Freq.Low 5150
LNB Frq. High 5150
Switch Type DiSEqC 1..4
Switch Port 1
Polarity Control 13/18V
LNB Freq. Band Control 0/22kHz
Ku/C Control Disable
LNB Type Index (1..8)
0/22kHz Control Off
0/12V Control Off
LNB Power On
1
2
4
3
5
6
7
8
9
10
11
× Type 1 Ø
i
Program Satellites
If you are unable to get any signal quality, please check the LNB Setting to ensure you have selected the corr
ect LNB and switch settings.
This menu is to align your dish to the selected satellite.
After setting the parameters, press the OK key to store th
e parameter values. And Start Search(Press OK) to searc
h the channels of transponder you want.
Refer to the Signal Quality bar and the Signal Lev
el bar at the bottom of the screen. It is recommend
ed that the signal is at the Medium level or higher.
If it is not , please adjust your satellite dish.
8
7
Program Satellite
Satellite 028.2° E
LNB Type Type1
TP/Polar 11478/H
Symbol Rate 30000
Position
Step Move E W
Search type Auto Search
Start Search(Press OK)
2
3
4
Set
Signal Level
Signal Quality
6
52%
63%
× ASTRA2 Ø
5
i
1
8
To Next Page
Loading...
