Eclipse ThermAir T/A Series v1.10, Installation Guide No. 114, 4/7/06
9
Safety
2
This section is provided as a guide for the safe operation of the
ThermAir burner system. All involved personnel should read
this section carefully before operating this system.
Danger:
The ThermAir burners, described herein, are
designed to mix fuel with air and burn the
resulting mixture. All fuel burning devices are
capable of producing fires and explosions if
improperly applied, installed, adjusted, controlled,
or maintained.
Do not bypass any safety feature; fire or explosion
could result.
Never try to light a burner if it shows signs of
damage or malfunction.
Warning:
The burner might have HOT surfaces. Always wear protective
clothing when approaching the burner.
Note:
This manual provides information in the use of these burners
for their specific design purpose. Do not deviate from any
instructions or application limits described herein without
written advice from Eclipse Combustion.
Read the entire manual before attempting to start this
system. If you do not understand any part of the information
contained in this manual, contact your local Eclipse
representative or Eclipse Combustion before continuing.
iNtroDuCtioN
safety
To Next Page
Loading...
Need help?
General
