4
THANK YOU!
Congratulations On Your Decision
To Purchase An
Easy-To-Operate And Easy-To-Maintain
ECO SPAs are built with simplicity of operation and easy maintenance in mind.
ECO SPA uses superior quality materials and top-of-the-line components and
controls to provide you with as trouble-free a hot tub experience as possible.
Side panel removal allows easy access to all interior ECO SPA plumbing and
equipment for easy maintenance or repair.
Refer to the diagrams found on pages 23 - 26 to identify the locations of the
components of your particular model ECO SPA.
Most service calls can be handled over the phone with your dealer.
Original spare or replacement ECO SPA parts are available by contacting your
dealer. Please refer to the Owner’s Record information that you recorded on the cover
of this manual to assist your dealer in determining your needs.
HELPFUL HINTS
The covers and Air Controls must be closed for the ECO SPA to heat up efficiently.
Heating time can vary depending on ambient air temperature, but generally if operating
on 110 Volts your ECO SPA will heat after fill-up at the rate of approximately 1.5° F
per hour. If the spa is operating at 220 Volts heating time will improve considerably to a
rate of approximately 3 ° - 6 ° F per hour depending on the model’s size & water volume.
While heating, condensation may develop and pool in various locations, especially
underneath the body of the spa and on the undersides of the spa’s covers which may
drip down the sides of the spa when the covers are opened. This accumulated
condensation can cause you to believe that the spa is leaking, but these seemingly
apparent leaks should be observed for a few days with the ECO SPA not in use
before proceeding with further investigation.
All Jets should be wide open to provide better water circulation for proper heating and
filtration when your ECO SPA is not in use.
To Next Page
Loading...
