8
INSTALLATION GUIDE
Please Read and Understand All Instructions Before Operating Your
SELECTING THE INSTALLATION LOCATION
Your new ECO SPA is completely self-contained. It can be set up on a patio, deck, or
indoors with special consideration.
Your ECO SPA must be installed on a relatively smooth, solid, flat and level surface
that will support 3,000 pounds. Concrete, bricks, pavers or wood deck are acceptable
permanent surfaces. The majority of the weight of the spa is placed under the foot well
area of the spa. This area must be firmly supported at all times.
DO NOT USE SHIMS, WEDGES, OR OTHER TYPES OF LEVELING DEVICES TO LEVEL THE SPA
It is critical that you do not use shims, wedges or other types of leveling devices to level
the spa. 100% CONTACT OF THE SPA’S FLOOR WITH THE SITE IS NECESSARY TO
PREVENT LONG TERM DISTORTION OF THE SPA SHELL (BODY) WHICH COULD AFFECT
THE FIT OF THE COVERS. IMPROPER INSTALLATION IN THIS MANNER MAY VOID YOUR
WARRANTY.
Do not place your ECO SPA in an area where the water will puddle around it.
Drainage of water away from the spa’s power cord and electrical equipment
compartment is necessary.
Place your ECO SPA away from areas where debris or dirt may be tracked into it.
Your ECO SPA should not be placed near or below electrical or telephone cables.
Consider privacy and wind shielding. A sheltered environment can result in lower
operating and maintenance costs.
Leave a minimum of 24 inches of open space at each end of the spa to ensure that the
cover will open and close properly.
Leave adequate space around the spa to allow full access to the Control System and
Pump access panels, Drain Cover and Power Cord cover plates. (See pages 23 - 26 of this
manual for a diagram of where these are located on your particular ECO SPA
model).
The proper site of your ECO SPA should be an area that is Not Accessible to
Children. Security fencing or Pool Yard gates should be in place to separate Children
from the Spa.
To Next Page
Loading...