Ecoflam Multicalor 70 User Manual

LB 1371
17.06.2004
Multicalor 45
Multicalor 70
Multicalor 100
Multicalor 120
Multicalor 140
PR/MD Gas / AB Gasolio
PR/MD Gas / AB Light oil
A
BRUCIATORI MISTI GAS + GASOLIO
B GAS/LIGHT-OIL DUAL BURNERS

Ecoflam Multicalor 70 Specifications

General

Fuel	Light oil
Efficiency	Up to 92%
Burner Type	Monoblock
Voltage	230 V
Frequency	50 Hz

Summary

TECHNICAL FEATURES

OPERATION OF BURNER WITH GAS

ADJUSTING THE COMBUSTION PROCESS

CONTROL BOXES LANDIS & STAEFA LGB21/LGB22 – LMG21/LMG22

SATRONIC DMG 972 CONTROL INFORMATION SYSTEM

ADJUSTMENT OF GAS MINIMUM PRESSURE SWITCH

ADJUSTMENT OF THE AIR PRESSURE SWITCH

ADJUSTEMENT OF THE COMBUSTION AIR

ADJUSTING THE MAXIMUM CAPACITY OF THE BURNER

ADJUSTING THE MINIMUM CAPACITY OF THE BURNER

OPERATION OF BURNER WITH LIGHT-OIL FUEL

PRIMING AND ADJUSTMENT OF OIL PUMP

NOZZLE CLEANING AND REPLACEMENT

FLAME DETECTION SYSTEM CHECK

ADJUSTING THE FIRING HEAD

DESCRIPTION OF CONTROL PANEL

RWF 40 MICROPROCESSOR REGULATOR

PROGRAMMING LEVELS

SETTING PARAMETERS

CHANGING THE SET POINT

SETTING PID PARAMETERS

DIFFERENTIAL SETTING FOR IGNITION AND SHUTOFF

PARAMETERIZATION

PROBE CONNECTION DIAGRAMS

C111 – C112 INPUT CONFIGURATION INDICATIONS

AUXILIARY CONTACT, TYPE OF REGULATOR, SET POINT “SP1” BLOCK C112. Parameter configuration

ERROR/FAULT INDICATION NUMBERS BLINKING IN DISPLAY

MAINTENANCE

YEARLY CHECKS

THE BURNER DOES NOT START

Troubleshooting steps for when the burner fails to start.

THE BURNER RUNS THE PREPURGING AND SWITCHES TO LOCKOUT AT THE END OF CYCLE

Troubleshooting for lockout after the prepurging phase.

THE BURNER RUNS THE PREPURGING BUT DOES NOT IGNITE

Troubleshooting steps for ignition failure during prepurging.

THE BURNERS IGNITES BUT SWITCHES TO LOCKOUT AFTER THE SAFETY TIME

Troubleshooting for lockout after the safety time has elapsed.

THE BURNERS IGNITES BUT SWITCHES TO LOCKOUT AFTER FEW MOMENTS

PARAMETERS LANDIS RWF 40