EasyManua.ls Logo

EcoFlow RIVER 3 - Regulatory Compliance

EcoFlow RIVER 3
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
should be properly disposed of or recycled.
2.
The product contains batteries. Please dispose of the product following
local laws and regulations for battery disposal and recycling. Do not dispose
of it with household waste to avoid environmental pollution and safety
hazards.
3.
If possible, ensure the battery is completely discharged (to 0% capacity)
before disposing of the product. If not, refrain from placing the battery
directly into a battery recycling box. Instead, contact a professional battery
recycling company for proper handling.
Regulatory Compliance
FCC Compliance Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the users authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20 cm between the radiator & your body.
IC Compliance Statement
When using the product, maintain a distance of 20 cm from the body to ensure
compliance with RF exposure requirements.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
This Class A digital apparatus complies with Canadian ICES-003.
Il doit être installé et utilisé à une distance minimale de 20 cm entre le
radiateur et toute partie de votre corps.
Le présent appareil est conforme aux CNR dIndustrie Canada applicables aux
appareils radio exempts de licence. Lexploitation est autorisée aux deux
conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.

Related product manuals