EcoFlow Smart Generator User Manual

7
Add Generator Engine Oil
There is no engine oil in the generator when delivered from the
factory. Do not start up the generator until after adding sufficient
engine oil. Do not tilt the generator when adding engine oil, to
prevent damage to the generator due to adding excessive oil.
1. Place the generator on a level plane.
2.
Turn the maintenance cover knob to and take off the maintenance cover.
3. Unscrew the lid and oil dipstick.
4. Inject the specified amount of recommended engine oil, and screw
the lid and oil dipstick closed tightly. Reinstall the maintenance cover
and turn the knob to Closed.
Recommended engine oil: SAE SJ 10W-40
Grade of recommended engine oil: SJ or higher
Oil capacity: 0.1 gal. / 0.38 L
Caution
Rechargeable Battery Connection
The generator cannot be started by the Electric Start switch unless
connected to the internal battery.
Turn the maintenance cover knob to
, take off the maintenance
cover and connect the positive and the negative wires of the battery
respectively.
Connecting the positive
and negative wires
Refilling the engine oil
Removing the
maintenance cover

EcoFlow Smart Generator Specifications

General

Fuel type	Liquefied Petroleum Gas (LPG), Petrol
Noise level	67 dB
Rated power	1800 W
Cooling type	Air
Maximum power	1900 W
Rated voltage	230 V
Ignition system	Manual/Electronic
Rated frequency	50 Hz
Fuel consumption	- l/h
Fuel tank capacity	4 L
AC outlets quantity	1 AC outlet(s)
Number of cylinders	1
Engine number of strokes	4
Continuous operating time @ maximum power @ rated voltage	3.5 h
Castor wheels	No
Product color	Black
Oil tank capacity	0.38 L
Carrying handle(s)	Yes

Weight and Dimensions

Depth	597 mm
Width	300 mm
Height	475 mm
Weight	30500 g