EcoFlow Smart Generator User Manual

15
1. Place the generator on a level plane, start it up and keep it running for several minutes to increase
its temperature. Then turn it off. Turn the Engine Switch and the fuel cap breather knob to "OFF".
2. Turn the maintenance cover knob to
and take off the maintenance cover.
3. Unscrew the lid and oil dipstick.
4. Place the oil basin under the generator and tilt the generator. The oil will drain quickly.
Tips: Improper disposal of engine oil may harm the environment. If you replace the engine oil yourself,
please dispose of the used oil properly. Store the used oil in a sealed container and take it to your
nearest oil recycling center. Do not pour it into any trash can, onto the ground or into the sewer.
5. Place the generator in its original horizontal state.
6. Refill the oil to the proper level.
7. Wipe the oil dipstick clean and remove any spilled oil.
Prevent any foreign objects from entering the inside of the engine.
8. Tighten the oil dipstick and lid.
9. Reinstall the maintenance cover and turn the knob to Closed.
Do not drain the engine oil immediately after the generator is switched off. The oil
temperature will be very high. Please take care not to get scalded when draining the oil.
3.3 Replacing the Engine Oil
Caution
Warning
Warning
Do not tilt the generator when adding engine oil to prevent damage to the generator due to
adding excessive oil.
1. Turn the maintenance cover knob to
and take off the maintenance cover.
2. Take off the screws and the air filter cover.
3. Take off the foam filter element.
4. Clean the foam filter element with soapy water or a nonflammable solvent
and dry it.
5. Add oil to the foam filter element and squeeze out the excess oil. The
foam filter element should be wet but should not drip any oil.
6. Place the foam filter element into the air filter.
Tips: 1. Make sure that the surface of the foam filter element is in close
contact with the air filter, leaving no gap between them.
2. Do not start the generator before reinstalling the air filter as excessive
toxic gas may be produced and foreign objects may enter the engine,
causing wear to the engine block.
7. Install the air filter cover back to its original position and tighten the screws.
8. Reinstall the maintenance cover and turn the knob to Closed.
3.4 Air Filter
Caution
Do not twist the foam filter element, to prevent any damage to it.
Removing the air filter cover
Wash clean Press and air dry
(donot twist)
Press (do not twist)Add correct
amount of oil

EcoFlow Smart Generator Specifications

General

Fuel type	Liquefied Petroleum Gas (LPG), Petrol
Noise level	67 dB
Rated power	1800 W
Cooling type	Air
Maximum power	1900 W
Rated voltage	230 V
Ignition system	Manual/Electronic
Rated frequency	50 Hz
Fuel consumption	- l/h
Fuel tank capacity	4 L
AC outlets quantity	1 AC outlet(s)
Number of cylinders	1
Engine number of strokes	4
Continuous operating time @ maximum power @ rated voltage	3.5 h
Castor wheels	No
Product color	Black
Oil tank capacity	0.38 L
Carrying handle(s)	Yes

Weight and Dimensions

Depth	597 mm
Width	300 mm
Height	475 mm
Weight	30500 g