EcoFlow Wave 2 User Manual

2
Safety Instructions
Use
1. Do not use this product near a heat source (such as re or heater), and avoid direct
exposure to sunlight. Doing so may cause ammable liquids to leak or explode.
2. If the product catches re by accident, we recommend that you use re extinguishers
in the following order: water or water mist, sand, re blanket, dry powder, and carbon
dioxide.
3. Keep the product away from any liquid. Do not get the product wet, and try to avoid
working in a wet location.
4. If the product is wet inside, immediately turn the power off and remove the power cord,
and place them in a safe open area. Stay away from the product until it is dry. Please take
measures to prevent electric shock when touching it. Do not operate or discard the dry
product without authorization. Please contact the customer service to dispose of it properly.
5. If there is dirt in any outlets, clean it with a dry cloth.
6. Do not use this product in environments with strong static electricity or magnetic elds
(such as a thunderstorm).
7. Do not touch product outlets with wires or other metal objects, otherwise the product may
short circuit.
8. Do not put your ngers into the air inlet/outlet.
9. Do not disassemble the product or extend any power cord without authorization since this
may result in electric shock or even re.
10. If the product components or power cords are damaged, they must be repaired and replaced
by the manufacturer, dealer or qualied electrical engineer to avoid hazardous conditions.
11. Do not place the battery where the air pressure is extremely low. As this may cause
ammable liquids to leak or explode.
12. Do not stand or sit on the product.
13. Do not pile heavy objects on the product.
14. Do not obstruct the air inlet/outlet or exhaust pipe during operation.
15. During the operation or transportation of the product, please avoid external damages, like
drops or impact to prevent any damages to the internal compressor. If the product is tilted
or impacted by a strong external force, immediately turn the power off and remove the
power cord. Leave it to stand for at least 6 hours before using.
16. Please store the product where it is dry and ventilated, and ensure that the distance
between the air inlet/outlet and the wall is >0.5 m.
17. Do not use unofcial components or accessories since they will void your warranty. If
they need to be replaced, please purchase them through the ofcial EcoFlow distribution
channels.
18. Please keep the product out of the reach of pets. Children should not operate this product
without supervision.
19. Electromagnetic elds created by this product may affect the normal functioning of
medical implants or personal medical devices, such as pacemakers, cochlear implants,

EcoFlow Wave 2 Specifications

General

Type	Monobloc mobile air conditioner
Wi-Fi	Yes
Noise level	56 dB
Refrigerating medium	R290
Cooling capacity (max)	5100 BTU/h
Heating capacity (max)	6100 BTU/h
Air conditioner functions	Cooling, Heating
Operating temperature (T-T)	5 - 50 °C
Refrigerating medium weight	130 g
Suitable for room area up to	10 m²
Cooling capacity in watts (max)	1500 W
Heating capacity in watts (max)	1800 W
International Protection (IP) code	IPX4
Cooling capacity in watts (nominal)	- W
Heating energy efficiency (COP, W/W)	-
Connected load	820 W
AC input voltage	100 - 240 V
AC input frequency	50/60 Hz
Power consumption (cooling)	550 W
Power consumption (heating)	600 W
Hourly energy consumption (cooling)	- kWh
Product color	Black, Grey

Weight and Dimensions

Depth	297 mm
Width	518 mm
Height	336 mm
Weight	14500 g