2
W
D
H
3.0 SPECIFICATIONS
Component Diagram
3.1 Dimensions
• Height: 21" (53.3 cm)
• Width: 10-1/2" (26.7 cm)
• Depth: 8-1/2" (21.6 cm)
This reservoir may be wall mounted or machine mounted.
Allow appropriate space, about 8" (20.3 cm), above the
reservoir for opening the cover as well as for the vacuum
breaker assembly.
3.2 Plumbing Requirements
A source of 120°F (48.9° C) to 150°F (65.5° C) water at a
minimum of 12 psi (.844 kgm/cm2) and 1 gallon per minute
(.063 liters/sec.) flow rate are required for the VANGUARD
Wash Max Reservoir.
Mayon tubing, 5/8" I.D. (15.9 mm), is required to direct the
effluent from the reservoir to the wash tank.
3.3 Electrical Requirements
The VANGUARD Wash Max Reservoir is supplied with a
20' (6 meter) length of 2 conductor cable. The conductors
are connected to the safety switch on the reservoir.
3.4 Components Not Supplied
• 5/8" I.D. (15.9mm) Mayon tubing
• 1/4" O.D. (6.4mm) copper tubbing
• Wall anchors (standard wall anchors or toggle bolts)
• Special mounting bracket (if required)
NOTE: Included in the VANGUARD Wash Max Reser-
voir package will be components common to both the
GUARDIAN and the Power Activator (vacuum breaker,
hose and assembly, hose clamps, needle valve, etc.).
To adapt the reservoir for a GUARDIAN product or
SOLID POWER product, one of the following must be
ordered.
1. GUARDIAN KIT
a. GUARDIAN Screen
b. Retaining Ring
c. GUARDIAN Safety Label and Nameplate
d. GUARDIAN Wall Chart
2. POWER ACTIVATOR KIT
a. Safety Grate
b. POWER ACTIVATOR Nameplate
c. POWER ACTIVATOR Wall Chart
d. Instructions - Conversion GUARDIAN to
POWER ACTIVATOR
To Next Page
Loading...
