Installation and Operating manual
Econ
®
Series 3300 Smart Valve Positioner www.eriks.com
Rev. 3 – January 22, 2019
4
1 Introduction
1.1 General Information for the users
Thank you for purchasing the Econ
®
series 3300 Smart Valve Positioner. Each product has been fully
inspected after its production to offer you the highest quality and reliable performance. Please read
the product manual carefully prior to installing and commission the product.
Ø For safety, it is important to follow the instructions in the manual. Econosto will not be held
responsible for any damages caused by user’s negligence.
Ø The manual should be provided to the end-user.
Ø Any modifications or repairs to the product may only be performed if expressed in this manual.
Ø The manual can be altered or revised without any prior notice. Any changes in product’s
specification, design, and/or any components may not be printed immediately but until the
following revision of the manual.
Ø The manual should not be duplicated or reproduced for any purpose without prior approval.
1.2 Manufacturer Warranty
Ø For the safety, it is important to follow the instructions in the manual. Manufacturer will not be
responsible for any damages caused by user’s negligence.
Ø Manufacturer will not be responsible for any damages or accidents as a result of any alteration or
modification of the product and its parts. If any alteration or modifications are necessary, please
contact Econosto directly.
Ø Manufacturer warrants the product from the date of original purchase of the product for one (1)
year, except as otherwise stated.
Ø Manufacturer warranty will not cover products that have been subjected to abuse, accidents,
alterations, modifications, tampering, negligence, misuse, faulty installation, lack of reasonable
care, repair or service in any way that is not contemplated in the documentation for the product,
or if the model or serial number has been altered, tampered with, defaced or removed; damages
that occurs in shipment, due to act of God, failure due to power surge, or cosmetic damage.
Improper or incorrectly performed maintenance will void this limited warranty.
1.3 Explosion Proof Warning (Only for Intrinsic safety type positioners)
Please ensure the unit is being used and installed in conformity with local, regional, and national
explosion proof within the proper safety barrier environment.
Ø Refer to paragraph 2.5 “Certifications”
Ø Explosion proof type of cables and gaskets should be used, when explosion gases are present
at the installation site.
Ø Positioner has 2 ports for power connection. Explosion proof type wires and packing should be
used. Blind plug is required when any port is not being used.
To Next Page
Loading...