ECOVACS DEEBOT T10 - Wi-Fi Connection; Charging DEEBOT; Connect Power Cord; Docking Station Placement

10
EN
Place this Docking Station against the wall and in more rooms, so your robot
will nd its way to charge more efciently when in a larger or more complex
home environment.
Note: Please do not place the Docking Station on the carpet.
Wi-Fi Connection
Charging DEEBOT
Before Wi-Fi setup, make sure DEEBOT, mobile phone, and Wi-Fi
network meet the following requirements.
DEEBOT and Mobile Phone Requirements
• DEEBOT is fully charged and the power switch of DEEBOT is turned on.
• Wi-Fi status light slowly ashes.
• Turn off mobile phone’s cellular data (you can turn it back on after setup).
Wi-Fi Network Requirements
• You are using a 2.4GHz or 2.4/5 GHz mixed network.
• Your router supports 802.11b/g/n and IPv4 protocol.
• Do not use a VPN (Virtual Private Network) or Proxy Server.
• Do not use a hidden network.
• WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.
• WEP EAP (Enterprise Authentication Protocol) is not supported.
• Use Wi-Fi channels 1-11 in North America and channels 1-13
outside North America (refer to local regulatory agency).
• If you are using a network extender/repeater, the network name
(SSID) and password are the same as your primary network.
Please be aware that the realization of intelligent functions such as
remote startup, voice interaction 2D/3D map display and control
settings, and personalized cleaning (depending on different products)
requires users to download and use ECOVACS HOME App, which
is constantly updated. You need to agree to our Privacy Policy and
User Agreement before we can process some of your basic and
necessary information and enable you to operate the product.If you
do not agree with our Privacy Policy and User Agreement, some of
the aforementioned intelligent functions cannot be realized through
ECOVACS HOME App, but you can still use the basic functions of
this product for manual operation.
After Wi-Fi connection,DEEBOT will enter into Networked Standby
mode if it has no signal input within 10 minutes.
1
2
Connect Power Cord
> 0.5m (1.64’)
> 0.5m (1.64’)
> 1.5m (4.92’)
Docking Station Placement