What to do if my EcoWater Water Dispenser shows Err05?
- DDiana WhiteAug 1, 2025
If your EcoWater Water Dispenser displays Err05, the suggested solution is to check the Electronic Control Board (PWA).
What to do if my EcoWater Water Dispenser shows Err05?
If your EcoWater Water Dispenser displays Err05, the suggested solution is to check the Electronic Control Board (PWA).
What to do if my EcoWater Water Dispenser shows Err03?
If your EcoWater Water Dispenser displays Err03, the suggested solutions are to check the Motor, Valve Position Switch, and Wire Harness.
What to do if my EcoWater Water Dispenser shows Err01?
If your EcoWater Water Dispenser displays Err01, the suggested solutions are to check the Motor and Valve Position Switch.
What to do if my EcoWater Water Dispenser shows Err04?
If your EcoWater Water Dispenser displays Err04, the suggested solution is to check the Valve Position Switch.
Brand | EcoWater |
---|---|
Model | ETF AIV-10 |
Category | Water Filtration Systems |
Language | English |
Follow installation instructions carefully. Check local plumbing and electrical codes. Use lead-free solder.
Procedure to set the current time on the controller display using UP/DOWN and SELECT buttons.
Procedure to set the number of days between automatic recharges based on household size and iron levels.
Procedure to set the desired start time for the automatic recharge cycle.
Procedure to adjust the backwash time from 0 to 99 minutes.
Procedure to adjust the aspirate time from 0 to 99 minutes.
Instructions for cleaning the nozzle and venturi assembly to ensure proper filter operation.
Filter's self-diagnostic function monitors electronic components and displays error codes for malfunctions.
Procedures to manually advance the filter through recharge cycles to check operation and switches.
Guide to identify problems like iron bleed, air in house lines, water to drain, and their causes/corrections.