EasyManua.ls Logo

EcoWater ESM15CE - User Manual

EcoWater ESM15CE
33 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
(4/20/04)
OWNERS MANUAL
How to maintain and operate your
EcoWater digital demand water system
EcoWater Digital Demand
MODELS
ESM11CE
ESM15CE
Ver sion 02 -- 2005
ļ

Table of Contents

Questions and Answers

  • R
    Robert ReevesAug 10, 2025
    Why is my EcoWater ESM15CE Water Filtration Systems water hard sometimes?
    • E
      Emma JonesAug 10, 2025
      If your EcoWater Water Filtration System is sometimes producing hard water, it could be due to several reasons: * The time setting is wrong. Check and correct the time setting. * The water hardness setting is incorrect. Refer to page 19 to find the correct settings. * The model code programmed is incorrect. Refer to page 18 to find the correct settings. * Hot water is being used while the softener is regenerating. Avoid using hot water during regeneration. * There may be a possible increase in water hardness. Test the raw water and program the timer accordingly. * There could be a leaking faucet or toilet valve, leading to excessive water usage. Fix all leaks.
  • F
    frank46Aug 25, 2025
    Why is the salt level not dropping in my EcoWater ESM15CE?
    • T
      Terry Stone PhDAug 25, 2025
      If your EcoWater Water Filtration System isn't producing soft water and the salt level in the storage tank isn't dropping, the salt may be bridged. Consult page 25 for instructions on how to break the salt bridge. Also, check if the manual bypass valve(s) are in the bypass position. If so, refer to figure 10 on page 16 to move the stem in the single bypass to the service position.
  • S
    Sydney CarterAug 31, 2025
    How to fix blank timer display on EcoWater ESM15CE Water Filtration Systems?
    • J
      Jeffrey LesterAug 31, 2025
      If the timer display on your EcoWater Water Filtration System is blank, it could be due to the following reasons: * The transformer is unplugged or the power cord is disconnected or defective. Check for power loss and correct it. Reset the timer and use the Recharge Now feature. * A fuse is blown, a circuit breaker has popped, or a circuit is switched off. Replace the fuse, reset the circuit breaker, or switch the circuit on. Use the Recharge Now feature. * The timer control board is defective. Replace the Electronic Control Board.
  • M
    Matthew ThomasNov 16, 2025
    What to do if EcoWater Water Filtration Systems has no soft water, tank full, and drain runs?
    • P
      Phillip BradyNov 16, 2025
      If your EcoWater Water Filtration System has no soft water, the salt storage tank is full of water, and water is running to the drain while the unit is in the water cycle, consider the following potential causes: * The nozzle & venturi may be dirty, plugged, or damaged. Take it apart, clean, and inspect it. * There may be an inner valve defect causing a leak. Replace the seals and rotor. * The valve drain hose may be plugged. Ensure the hose has no kinks, sharp bends, or blockages. * The system water pressure may be too low or high. Increase well pump output to a minimum of 1.4 bar if the pressure is low. Add a pressure reducing valve if the daytime pressure is over 7 bar. * The brine valve float kit may be dirty or defective. Clean or replace the valve float kit assembly. * T...

Summary

Unpacking and Inspection

Safety Guides

Planning Installation

Inlet - Outlet Plumbing Options

Discusses options for connecting the water softener's inlet and outlet pipes.

Select Installation Location

Provides guidelines for choosing the optimal location for the unit.

Installation

Turn Off Water Supply & Move Unit

Steps for turning off water and positioning the softener unit for installation.

Plumbing Connections

Assembling and connecting inlet/outlet plumbing for the softener.

Drain and Grounding Setup

Installing drain hoses and ensuring proper electrical grounding.

Testing and Sanitization

Performing leak tests, adding salt, and sanitizing the softener.

Electrical and System Restart

Programming the Digital Demand Faceplate Controller

Model Code Configuration

Faceplate Controller Features and Options

Advanced;Service Menu

Advanced Operational Settings

Routine Maintenance

Refilling With Salt

Breaking A Salt Bridge

Troubleshooting Guide

EcoWater ESM15CE Specifications

General IconGeneral
BrandEcoWater
ModelESM15CE
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals