37
Using BIOS
Supervisor Password Page
Load Default Setting
This option opens a dialog box to ask if you are sure to install optimized defaults or
not. You select [OK], and then press <Enter>, the Setup Utility loads all default
values; or select [Cancel], and then press <Enter>, the Setup Utility does not load
default values.
This page helps you install or change a password.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Supervisor Password
Item Help
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults
mnlk
Supervisor Password : Not Installed
Change Supervisor Password Press Enter
Install or Change the
password.
Supervisor Password (Not Installed)
This item indicates whether a supervisor password has been set. If the password has
been installed, Installed displays. If not, Not Installed displays.
Change Supervisor Password
You can select this option and press <Enter> to access the sub menu. You can use
the sub menu to change the supervisor password.
This page helps you install or change a password.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
User Password
Item Help
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults
mnlk
User Password : Not Installed
User Password Page
User Password (Not Installed)
This item indicates whether a user password has been set. If the password has been
installed, Installed displays. If not, Not Installed displays.
To Next Page
Loading...
