41
Using BIOS
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have
installed in your system.
M.I.B.III (MB Intelligent BIOS III) Menu
Memory Clock (Auto)
This item is used to set the memory clock.
Press <Esc> to return to the M.I.B.III Menu page.
Memory Mode (Auto)
This item is used to set the memory Mode.
RAS# to CAS# Delay(tRD) (9CLK)
This item specifies the RAS# to CAS# delay to Rd/Wr command to the same bank.
RAS# Active Time(tRAS) (24CLK)
This item specifies the RAS# active time.
Row Precharge Time(tRP) (9CLK)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
CAS#Latency(tcl) (9CLK)
This item determines the operation of DDR SDRAM memory CAS (column address
strobe). It is recommanded that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
Memory Clock DCT0 is (DDR-1333/667Mhz)
This item shows current memory clock of DCT0.
Memory Clock DCT1 is (None)
This item shows current memory clock of DCT1.
Main Advanced Chipset M.I.B III Boot Security Exit
+/- : Change Opt.
Enter/Dbl Click : Select
lk
mn
: Select Screen
/Click: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
This Option Allows User
to select different Memory
Clock.
Default value is 400Mhz.
Memory Clock Auto
Memory Mode Auto
Memory Clock DCT0 is : DDR-1333/667Mhz
Memory Clock DCT1 is : None
CAS# Latency (tCL) 9 CLK
RAS# to CAS# Delay (tRCD) 9 CLK
Row Precharge Time (tRP) 9 CLK
RAS# Active Time (tRAS) 24 CLK