36
Using BIOS
Power Management Setup
This page sets up some parameters for system power management operation.
Power Off
Power On
Last State
Help Item
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
AC Power Loss by IO Power Off
ACPI Suspend Type S3 (STR)
Soft-off by PWR-BTTN Instant Off
Resume By PCI/PCI-E/Lan PME Enabled
Resume By USB Enabled
Resume By PS2 KB (S3) Disabled
Resume By PS2 MS (S3) Enabled
Resume By RTC Alarm Disabled
Press <Esc> to return to the main menu setting page.
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
: Move
mnlk
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
USB Controller (Enabled)
OnBoard LAN Function (Auto)
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Onboard AUDIO Function (Auto)
OnBoard Floppy Controller (Enabled)
Use this item to enable or disable the onboard floppy disk drive interface.
This item enables the USB controller. Leave this at the default “Enabled” if you want
to connect USB devices to your computer.
Use this item to enable or disable the onboard audio device.
To Next Page
Loading...
Need help?
General
