ECS H61H2-M16 - Super Io Configuration

H61H2-M16 USER MANUAL
39
Chapter 3


Super IO Configuration
Use this item to show the information of the Super IO Configuration.
Super IO Configuration
Super IO Chip IT8728
Serial Port 0Configuration
Serial Port 1 Configutation
Parallel Port Configutation
Set Parameters of Floppy Disk
Controller (FDC)






Super IO Chip (IT8728)
This item shows the information of the super IO chip.



Serial Port 0 Configuration
Scroll to this item and press <Enter> to view the following screen:
Serial Port 0 Configuration
Serial Port [Enabled]
Device Settings IO=3F8h; IRQ=4;
Change Settings [Auto]
Enable or Disable Floppy Disk
Controller
F1:General Help
+/- : Change Opt.
Enter : Select


:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Press <Esc> to return to the Super IO Configuration page.
F2:Previous Values
F1:General Help
+/- : Change Opt.
Enter : Select


:Select Screen
:Select Item
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Serial Port (Enabled)
This item allows you to enable or disable serial port.
Device Settings (IO=3F8h; IRQ=4)
This item shows the information of the device settings.
Change Settings (Auto)
Use this item to change device settings.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1229. Copyright (C) 2012, American Megatrends, Inc.
Main
Advanced Chipset M.I.B III Boot Security Exit
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1229. Copyright (C) 2012, American Megatrends, Inc.
Main Advanced Chipset M.I.B III Boot Security Exit