Chapter 3
H61H2-TI USER MANUAL
38
Limit CPUID Maximum (Disabled)
Use this item to enable or disable the maximum CPUID value limit, you can enable
this item to prevent the system from “rebooting” when trying to install Windows NT
4.0.
CPU Configuration
The item in the menu shows the CPU Configuration.
Main Advanced Chipset Frequency/Voltag Boot Security Exit
Intel(R) Core(TM) i5-3330S CPU @ 2.70GHz
This is display-only field and diaplays the information of the CPU installed in your
computer.
64-bit (Supported)
This item shows the computer supports EMT64.
Processor Speed (2700MHz)
This item shows the current processor speed.
Processor Stepping (306a9)
This item shows the processor stepping version.
Microcode Revision (12)
This item shows the Microcode version.
Processor Cores (4)
This item shows the core number of the processor.
Intel HT Technology (Not Supported)
This item shows that the computer supports Intel HT Technology.
Intel VT-x Technology (Supported)
This item shows that the computer supports Intel VT-x Technology.
Number of cores to enable
in each processor package.
CPU Configuration
Intel(R) Core(TM) I5-3330S CPU @ 2.70GHz
64-bit Supported
Processor Speed 2700 MHz
Processor Stepping 306a9
Microcode Revision 12
Processor Cores 4
Intel HT Technology Not Supported
Intel VT-x Technology Supported
Active Processor Cores All
Limit CPUID Maximum Disabled
Execute Disable Bit Enabled
Intel Virtualization Technology Enabled
CPU C3 Report Disabled
CPU C6 Report Enabled
Enhanced Halt (C1E) Enabled
Active Processor Cores (All)
This item shows the number of cores to enable in each processor package.
+/- : Change Opt.
Enter : Select
: Select Screen
: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC : Exit
To Next Page
Loading...
Need help?
General
