3-14
HDD Power Down [Disabled]
The IDE hard drive will spin down if it is not accessed within a specified length of
time.
Suspend Mode [Disabled]
The CPU clock will be stopped and the video signal will be suspended if no Power
Management events occur for a specified length of time. Full power function will
return when a Power Management event is detected.
Video Off Option (Suspend —> Off)
This option defines if the video is powered down when the system is put into suspend
mode.
Video Off Method (V/H SYNC+Blank)
This selection will cause the system to turn off the vertical and horizontal synchroni-
zation ports and write blanks to the video buffer.
MODEM Use IRQ (3)
If you want an incoming call on a modem to automatically resume the system from a
power-saving mode, use this item to specify the interrupt request line (IRQ) that is
used by the modem. You might have to connect the fax/modem to the motherboard
Wake On Modem connector for this feature to work.
Soft-Off by PWRBTN (Instant-Off)
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed
by Wake Up Alarms. This item lets you install a software power down that is controlled
by the power button on your system. If the item is set to Instant-Off, then the power
button causes a software power down. If the item is set to Delay 4 Sec. then you have
to hold the power button down for four seconds to cause a software power down.
Run VGABIOS if S3 Resume [Auto]
This item allows the system to initialize the VGA BIOS from S3 (Suspend to RAM)
sleep state.
Power on After Power-fail (Off)
This item enables your computer to automatically restart or return to its last operating.
AMD K8 Cool’n’Quiet control (Auto)
IRQ/Event Activity Detect (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Phoenix-AwardBIOS CMOS Setup Utility
IRQ/Event Activity Detect
PS2KB Wakeup Select [Hot key]
PS2KB Wakeup from S1-S3 [Disabled]
Power Button Lock for S3 Disabled
PS2MS Wakeup from S1-S3 [Disabled]
USB Resume from S3 [Disabled]
VGA [OFF]
LPT & COM [LPT/COM]
HDD & FDD [ON]
PCI Master [OFF]
PowerOn by PCI Card [Enabled]
Modem Ring Resume [Disabled]
RTC Alarm Resume [Disabled]
Date (of Month) 0
Resume Time (hh: mm: ss) 0: 22: 0
IRQs Activity Monitoring [Press Enter]
Item Help
Menu Level
F5:Previous Values F6:Performance Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
X
X
X
When Select Password,
Please press ENTER key to
change Password Max 8
numbers.
This item helps the system to lower the frequency when CPU idles. When the
frequency decreases, the temperature will drop automatically as well.
To Next Page
Loading...
Need help?
General
