EasyManuals Logo

ECS KV2 Extreme User Manual

ECS KV2 Extreme
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
5-15
that appears on screen, and then press the Enter key.
5. Press Enter to continue with installation or if you need to specify
any additional devices to be installed, do so at this time. Once all
devices are specified, Press Enter to continue with installation.
6. From the Windows 2000/XP Setup screen, press the Enter key.
Setup will now load all device files and then continue the Windows
2000/XP installation.
7. Please install the driver package again (ex. SiS RAID driver v1.00)
while the operation system has been setup.
Remark: If you would like to install windows to any RAID set, you should create RAID
from BIOS utility or SiS180 RAID Utility first and then follow the steps
above.
5.8-2 Existing Windows 2000/XP/98/Me Installation
1. Install the driver by executing SiS driver setup utility.
2. The drivers will be automatically installed.
5.8-3 Confirming Windows 2000/XP Driver Installation
1. From Windows 2000/XP, open the Control Panel from “My
Computer” followed by the System icon.
2. Choose the “Hardware” tab, then click the “Device Manager” tab.
3. Click the “+” in front of “SCSI and RAID Controllers” hardware
type. The driver “SiS 180 Raid Controller” should appear.
5.8-4 Confirming Windows 98/Me Driver Installation
1. From Windows 98/Me, open the Control Panel from “My Com-
puter” followed by the System icon.
2. Choose the “Device Manager” tab.
3. Click the “+” in front of “IDE ATA/ATAPI Controllers” hardware
type. The driver “SiS 180 IDE Dual Channel” and “SiS 180 IDE/
RAID Controller” should appear.
5.9 BIOS Utility Operation
BIOS Utility supports windows 2000/XP/98/Me.
5.9-1 Starting BIOS Utility
1. Boot your system. If this is the first time you have booted with the
SiS180 and the drives installed, the BIOS will display the
following:
2. Press <Ctrl-S> keys to display the SiS 964/180 Utility Main Menu.
Silicon Integrated Systems Corp. RAID BIOS Setting Utility v0.XX
(c) 2003-2005 Silicon Integrated Systems Corp. All Rights Reserved.
Press <Ctrl.<S> to run BIOS Setting Utility

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ECS KV2 Extreme and is the answer not in the manual?

ECS KV2 Extreme Specifications

General IconGeneral
BrandECS
ModelKV2 Extreme
CategoryMotherboard
LanguageEnglish

Related product manuals