5-7
5.1-10 Rebuild Broken RAID 1 Array
When booting up the system, BIOS will detect if any member disk drives of
RAID has failed or is absent. If BIOS detects any disk drive failures or
missing disk drives, the status of the array will be marked as broken.
If BIOS detects a broken RAID 1 array but there is a spare hard drive
available for rebuilding the broken array, the spare hard drive will automati-
cally become the mirroring drive. BIOS will show a main interface just like
a duplicated RAID 1. Selecting Continue to boot enables the user to
duplicate the array after booting into operating system.
If BIOS detects a broken RAID 1 array but there is no spare hard drive
available for rebuilding the array, BIOS will provide several operations to
solve such problems.
1. Power off and Check the Failed Drive:
This item turns off the computer and replaces the failed hard drive with a
good one. If your computer does not support APM, you must turn off your
computer manually. After replacing the hard drive, boot into BIOS and
select Choose replacement drive and rebuild to rebuild the broken
array.
To Next Page
Loading...
Need help?
General
