3-7
3.3-3 Advanced Chipset Features
These items define critical timing parameters of the mainboard. You
should leave the items on this page at their default values unless you are
very familiar with the technical specifications of your system hardware.
If you change the values incorrectly, this may cause fatal errors or
instability into your system.
AGP & P2P Bridge Control [Press Enter]
DRAM Clock/Drive Control [Press Enter]
LDT & PCI Bus Control [Press Enter]
VLink Data Rate [8X]
Init Display First [PCI Slot]
Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
Advanced Chipset Features
F5:Previous Values F6:Performance Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
AGP & P2P Bridge Control (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
AGP Aperture Size [128M]
This item defines the size of aperture if you use an AGP graphics adapter. The AGP
aperture refers to a section of the PCI memory address range used for graphics
memory. We recommend that you leave this item at the default value.
AGP 2.0 Mode (4X)
This item allows you to enable or disable the caching of display data for the
processor video memory. Enabling AGP-8X Mode can greatly improve the display
speed. Disable this item if your graphics display card does not support this feature.
AGP Aperture Size [128M]
AGP 2.0 Mode [4X]
AGP Driving Control [Auto]
AGP Driving Value [DA]
AGP Fast Write [Disabled]
AGP Master 1 WS Write [Disabled]
AGP Master 1 WS Read [Disabled]
AGP 3.0 Calibration [Enabled]
Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
Advanced Chipset Features
F5:Previous Values F6:Performance Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
X
To Next Page
Loading...
Need help?
General
