3-5
Halt On [All, But Keyboard]
This item defines the operation of the system POST (Power On Self Test) routine.
You can use this item to select which types of errors in the POST are sufficient to
halt the system.
Base Memory, Extended Memory and Total Memory
These items are automatically detected by the system at start up time. These are
display-only fields. You cannot make chanages to these fields.
3.3-2 Advanced BIOS Features
This option defines advanced information about your system.
ATA 66/100 IDE Cable Msg (Enabled)
Enables or disables the ATA 66/100 IDE Cable Msg. This message will appear during
reboot when you use 40-pin cable on your 66/100 hard disks.
Hard Disk Boot Priority
Scroll to this item and press <Enter> to view the following screen:
1. Pri.Master:
2. Pri.Slave:
3. Sec. Master:
4. Sec. Slave:
5. USBHDD0:
6. USBHDD1:
7. USBHDD2:
8. Bootable Add-in Cards
Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
Hard Disk Boot Priority
: Move PU/PD+/-/:Change Priority F10:Save ESC:Exit
Use <
> or < > to
select a device, then press
<+> to move it up, or <-> to
move it down the list. Press
<ESC> to exit this menu.
Quick Power On Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
First/Second/Third Boot Device (Floppy/Hard Disk/CDROM)
Use these three items to select the priority and order of the devices that your system
ATA 66/100 IDE Cable Msg. [Enabled]
Hard Disk Boot Priority [Press Enter]
Quick Power On Self Test [Enabled]
First Boot Device [Floppy]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Boot Other Device [Enabled]
Swap Floppy Drive [Disabled]
Boot Up Floppy Seek [Disabled]
Boot Up NumLock Status [On]
Typematic Rate Setting [Disabled]
Typematic Rate (Chars/Sec0 6
Typematic Delay (Msec) 250
Security Option [Setup]
APIC Mode [Enabled]
HDD S.M.A.R.T. Capability [Disabled]
VIdeo BIOS Shadow [Enabled]
Small Logo(EPA) Show [Disabled]
Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
Advanced BIOS Features
F5:Previous Values F6:Performance Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
X
X
To Next Page
Loading...
Need help?
General
