5-22
3. You will have two selections to create a RAID 0+1 array. The
default value is <1>. If you select <1>Auto Create, you can
create a RAID 0+1 array faster and easier. The result after creating
will be show on step 6. Besides, you also can select <2>Manual
Create, see following steps.
4. Use <1>-<5> keys and <Enter> to select Block Size. (Default: 64K)
5. Use <> <> to select disk, and press <Enter> to select disk. <Q>
to exit. When you press <Enter> on the disk you wanted, the RAID
Type will be changed from Single to RAID 0+1.
6. After all steps finished, press <Q> until escape the setup menu and
RAID 0+1 array will be show on the top of the main frame.
To Next Page
Loading...
Need help?
General
