Video Power Down Mode
Use this item to determine which power-saving mode is required to power
down the graphics sub-system. You can force the graphics to power down in
Stand By or Suspend modes, or you can disable the power down.
Hard Disk Power Down Mode
Use this item to determine which power-saving mode is required to power
down the hard disk drive(s). You can force the hard disk to power down in
Stand By or Suspend modes, or you can disable the powerdown.
Standby Time Out (Minute)
This sets the timeout for Standby mode in minutes. If the time selected passes
without any system activity, the computer will enter power-saving Standby
mode.
Suspend Time Out (Minute)
This sets the timeout for Suspend mode in minutes. If the time selected
passes without any system activity, the computer will enter power-saving Sus-
pend mode.
PowerOn by LAN/Ring
The system can be turned off with a software command. If you enable this
item, the system can automatically resume if there is an incoming call on the
Modem. You must use an ATX power supply in order to use this feature.
PowerOn by Onchip LAN
The system can be turned off with a software command. If you enable this
item, the system can automatically resume on LAN. You must use an ATX
power supply in order to use this feature.
PowerOn by KCB Wake up key/Wake up password
If you enable this item, system can automatically resume by pressing hot
keys on the keyboard or typing in the password. You must enable the Key-
board Power On jumper and use an ATX power supply in order to use this
feature.
PowerOn by RTC Alarm/Date/Hour/Minute/Second
The system can be turned off with a software command. If you enable this
item, the system can automatically resume at a fixed time based on the sys-
tem’s RTC (realtime clock). Use the items below this one to set the date and
time of the wake-up alarm. You must use an ATX power supply in order to use
this feature.
30
To Next Page
Loading...
Need help?
General
