30
Using BIOS
This item allows users to enable or disable the CPU Hyper-Threading function.
Press <Esc> to return to the Advanced BIOS Features page.
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
IDE Configuration
Help Item
IDE Configuration (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
IDE Configuration
Parallel ATA IDE Device
SB IDE Controller [Both]
Primary IDE Master : [Not Detected]
Primary IDE Slave : [Not Detected]
Secondary IDE Master : [Not Detected]
Secondary IDE Slave : [Not Detected]
Serial ATA IDE Device
SB SATA RAID BIOS : [Enabled]
Third IDE Master : [Not Detected]
Fourth IDE Master : [Not Detected]
Fifth IDE Master : [Not Detected]
Sixth IDE Master : [Not Detected]
Hard Dsik Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA (PI) 80Pin Cable Detection [Host]
IDE Ultra DMA Mode [Enabled]
: Move
F10: Save
F1: General help
+/-/: Value
Enter : Select
ESC: Exit
F9: Optimized Defaults
F8: Fail-Safe DefaultsF7:Previous Values
DISABLED: disables the
integrated IDE Controller.
PRIMARY: enables only
the Primary IDE Controller
SECONDARY: enables
only the Secondary IDE
Controller.
BOTH: enables both IDE
Controllers
SB IDE Controller (Both)
This item enables or disables the integrated IDE controllers. If set to DISABLED, it disables
the integrated IDE Controller, if set to Primary, it enables only the Primary IDE Control-
ler, if set to SECONDARY, it enables only the Secondary IDE Controller, if set to BOTH,
it enables both IDE Controllers.
Primary/Secondary IDE Master/Slave & Third/Fourth/Fifth/Sixth IDE
Master (Not detected) (Press Enter)
Your computer has four IDE channels and each channel can be installed with one or two
devices (Master and Slave). In addition, this motherboard supports four SATA channels and
each channel allows one SATA device to be installed. Use these items to configure each
device on the IDE channel.
SB SATA RAID BIOS (Enabled)
This item enables or disables the SB SATA RAID BIOS function.
CPU Hyper-Threading (Enabled)
Hard Disk Write Protect (Disabled)
Use this item to enable or disable hard disk write protection.
IDE Detect Time Out (35)
This item allows you to set time out for IDE detection.
ATA(PI) 80Pin Cable Detection (Host)
Select the mechanism for detecting 80Pin ATA(PI) Cable.
To Next Page
Loading...
Need help?
General
