CADENCE II Fetal Monitor User Manual
- 46 -
5 Press the UP key or DOWN key to move the cursor to GesWeek, press the CHANNEL
key. Input the patient’s name in the same way. Press the CHANNEL to confirm selection.
6 Press the UP key or DOWN key to move the cursor to GesDay, press the CHANNEL key.
Input the patient’s name in the same way. Press the CHANNEL to confirm selection.
7 Press the AUTO key to exit.
7.8.3 Enabling / Disabling Manual Login
If the manual login is enabled, the login menu pops up when you press the AUTO key to start
monitoring. To enable or disable the manual login,
1 Press the SETUP key six times to open the Auto Monitor menu.
2 Press the UP key or DOWN key to move the cursor to Login; press the CHANNEL key.
3 Press the UP key or DOWN key to toggle between ON and OFF (default).
4 Press the CHANNEL key to confirm selection.
5 Press the AUTO key to exit.
The monitoring starts immediately after exiting from the menu.
7.9 Start Monitoring
After the AUTO key is pressed, the monitor automatically zeroes the TOCO value, clears FM
count, adjusts fetal heart audio volume to default level, zeroes the monitoring time length and
starts monitoring.
If the Auto-print is switched off, press the PRINT key to start printing.
7.10 Screen Display
Figure 7-9 Fetal monitoring screen display
To Next Page
Loading...
Need help?
General
