Chapter 4
| System Management Commands
Time
– 148 –
Command Usage
This command sets the local time zone relative to the Coordinated Universal Time
(UTC, formerly Greenwich Mean Time or GMT), based on the earth’s prime meridian,
zero degrees longitude. To display a time corresponding to your local time, you
must indicate the number of hours and minutes your time zone is east (before) or
west (after) of UTC.
Example
Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
Console(config)#
Related Commands
show sntp (139)
calendar set
This command sets the system clock. It may be used if there is no time server on
your network, or if you have not configured the switch to receive signals from a
time server.
Syntax
calendar set
hour min sec {day month year | month day year}
hour - Hour in 24-hour format. (Range: 0 - 23)
min - Minute. (Range: 0 - 59)
sec - Second. (Range: 0 - 59)
day - Day of month. (Range: 1 - 31)
month -
january
|
february
|
march
|
april
|
may
|
june
|
july
|
august
|
september
|
october
|
november
|
december
year - Year (4-digit). (Range: 1970 - 2037)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Note that when SNTP is enabled, the system clock cannot be manually configured.
Example
This example shows how to set the system clock to 15:12:34, February 1st, 2015.
Console#calendar set 15:12:34 1 February 2015
Console#
To Next Page
Loading...
Need help?
General