Chapter 50
| IP Routing Commands
Border Gateway Protocol (BGPv4)
– 1084 –
neighbor filter-list Filters route updates sent to or received from a neighbor
based on an AS path access-list
RC
neighbor interface Specifies the interface to a neighbor RC
neighbor maximum-prefix Sets the maximum number or route prefixes that can be
received from a neighbor
RC
neighbor next-hop-self Configures the local router as the next hop for a neighbor RC
neighbor
override-capability
Overrides the result of capability negotiations, allowing a
session to be formed with a peer that does not support
capability negotiation
RC
neighbor passive Passively forms a connection with the specified neighbor,
not sending a TCP connection request, but waiting a
request from the specified neighbor
RC
neighbor password Enables MD5 authentication and sets the key for a
neighboring router
RC
neighbor peer-group
(Creating)
Configures a router peer group which can be easily
configured with the same attributes
RC
neighbor peer-group
(Group Members)
Assigns routers to a peer group RC
neighbor port Specifies the TCP port number of the partner through
which communications are carried
RC
neighbor prefix-list Configures prefix restrictions applied in inbound/
outbound route updates to/from specified neighbors
RC
neighbor remote-as Configures a neighbor and its AS number, identifying the
neighbor as a local AS member
RC
neighbor
remove-private-as
Removes private autonomous system numbers from
outbound routing updates to an external neighbor
RC
neighbor route-map Specifies the route mapping policy for inbound/outbound
routing updates for specified neighbors
RC
neighbor
route-reflector-client
Configures this router as a route reflector and the specified
neighbor as its client
RC
neighbor
route-server-client
Configures this router as a route server and the specified
neighbor as its client
RC
neighbor send-community Configures the router to send community attributes to a
neighbor in peering messages
RC
neighbor shutdown Closes a neighbor connection without canceling the
neighbor configuration
RC
neighbor soft-
reconfiguration inbound
Configures the switch to store updates in the inbound
message buffer, and perform soft re-configuration from
this buffer for specified neighbors when required
RC
neighbor strict-capability-
match
Forces strict capability matching when establishing
connections
RC
neighbor timers Sets the Keep Alive time and Hold time used for specified
neighbors
RC
neighbor timers connect Sets the time to wait before attempting to reconnect to a
neighbor whose TCP connection has failed
RC
neighbor unsuppress-map Allows specified suppressed routes to be advertised RC
Table 23: Border Gateway Protocol Commands – Version 4 (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General