Chapter 4
| System Management Commands
Event Logging
– 167 –
Example
Console(config)#logging history ram 0
Console(config)#
logging host This command adds a syslog server host IP address that will receive logging
messages. Use the no form to remove a syslog server host.
Syntax
logging host host-ip-address [port udp-port]
no logging host host-ip-address
host-ip-address - The IPv4 or IPv6 address of a syslog server.
udp-port - UDP port number used by the remote server. (Range: 1-65535)
Default Setting
UPD Port: 514
Command Mode
Global Configuration
Command Usage
◆ Use this command more than once to build up a list of host IP addresses.
◆ The maximum number of host IP addresses allowed is five.
Example
Console(config)#logging host 10.1.0.3
Console(config)#
logging on This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
None
Command Mode
Global Configuration
To Next Page
Loading...
