Edge-Core ECS4620-28F-2AC - Page 506

Chapter 16 | Loopback Detection Commands
– 506 –
show loopback-
detection
This command shows loopback detection configuration settings for the switch or
for a specified interface.
Syntax
show loopback-detection [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
Command Mode
Privileged Exec
Example
Console#show loopback-detection
Loopback Detection Global Information
Global Status : Enabled
Transmit Interval : 10
Recover Time : 60
Action : Shutdown
Trap : None
Loopback Detection Port Information
Port Admin State Oper State
-------- ----------- ----------
Eth 1/ 1 Enabled Normal
Eth 1/ 2 Disabled Disabled
Eth 1/ 3 Disabled Disabled
.
.
.
Console#show loopback-detection ethernet 1/1
Loopback Detection Information of Eth 1/1
Admin State : Enabled
Oper State : Normal
Looped VLAN : None
Console#