Chapter 19
| Spanning Tree Commands
– 526 –
spanning-tree
forward-time
This command configures the spanning tree bridge forward time globally for this
switch. Use the no form to restore the default setting.
Syntax
spanning-tree forward-time seconds
no spanning-tree forward-time
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
Default Setting
15 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a port will wait before
changing states (i.e., discarding to learning to forwarding). This delay is required
because every device must receive information about topology changes before it
starts to forward frames. In addition, each port needs time to listen for conflicting
information that would make it return to the discarding state; otherwise, temporary
data loops might result.
Example
Console(config)#spanning-tree forward-time 20
Console(config)#
spanning-tree
hello-time
This command configures the spanning tree bridge hello time globally for this
switch. Use the no form to restore the default.
Syntax
spanning-tree hello-time time
no spanning-tree hello-time
time - Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) - 1].
Default Setting
2 seconds
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General