Chapter 22
| Class of Service Commands
Priority Commands (Layer 3 and 4)
– 643 –
show qos map
trust-mode
This command shows the QoS mapping mode.
Syntax
show qos map trust-mode interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
Command Mode
Privileged Exec
Example
The following shows that the trust mode is set to CoS:
Console#show qos map trust-mode interface ethernet 1/5
Information of Eth 1/5
CoS Map Mode: CoS mode
Console#
To Next Page
Loading...
