Edge-Core ECS4620-28F-2AC - Page 668

Chapter 24 | Multicast Filtering Commands
IGMP Snooping
– 668 –
Example
The following example enables IGMP snooping globally.
Console(config)#ip igmp snooping
Console(config)#
ip igmp snooping
priority
This command assigns a priority to all multicast traffic. Use the no form to restore
the default setting.
Syntax
ip igmp snooping priority priority
no ip igmp snooping priority
priority - The CoS priority assigned to all multicast traffic. (Range: 0-7, where
7 is the highest priority)
Default Setting
2
Command Mode
Global Configuration
Command Usage
This command can be used to set a high priority for low-latency multicast traffic
such as a video-conference, or to set a low priority for normal multicast traffic not
sensitive to latency.
Example
Console(config)#ip igmp snooping priority 6
Console(config)#
Related Commands
show ip igmp snooping (684)