Chapter 24
| Multicast Filtering Commands
MLD Snooping
– 711 –
ipv6 mld snooping
vlan static
This command adds a port to an IPv6 multicast group. Use the no form to remove
the port.
Syntax
[no] ipv6 mld snooping vlan vlan-id static ipv6-address interface
vlan - VLAN ID (Range: 1-4094)
ipv6-address - An IPv6 address of a multicast group. (Format: X:X:X:X::X)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
None
Command Mode
Global Configuration
Example
Console(config)#ipv6 mld snooping vlan 1 static ff00:0:0:0:0:0:0:10c ethernet
1/6
Console(config)#
clear ipv6 mld
snooping groups
dynamic
This command clears multicast group information dynamically learned through
MLD snooping.
Syntax
clear ipv6 mld snooping groups dynamic
Command Mode
Privileged Exec
Command Usage
This command only clears entries learned though MLD snooping. Statically
configured multicast address are not cleared.
Example
Console#clear ipv6 mld snooping groups dynamic
Console#
To Next Page
Loading...
Need help?
General