Chapter 27
| OAM Commands
– 869 –
show efm oam
counters interface
This command displays counters for various OAM PDU message types.
Syntax
show efm oam counters interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces; use a
hyphen to designate a range of ports. (Range: 1-28/52)
Command Mode
Normal Exec, Privileged Exec
Example
Console#show efm oam counters interface 1/1
Port OAMPDU Type TX RX
---- --------------------- ---------- ----------
1/1 Information 1121 1444
1/1 Event Notification 0 0
1/1 Loopback Control 1 0
1/1 Organization Specific 76 0
Console#
show efm oam
event-log interface
This command displays the OAM event log for the specified port(s) or for all ports
that have logs.
show efm oam event-log interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces; use a
hyphen to designate a range of ports. (Range: 1-28/52)
Command Mode
Normal Exec, Privileged Exec
Command Usage
â—† When a link event occurs, no matter whether the location is local or remote, this
information is entered in the OAM event log.
â—† When the log system becomes full, older events are automatically deleted to
make room for new entries.
To Next Page
Loading...
Need help?
General