Chapter 29
| DHCP Commands
DHCP Server
– 901 –
netbios-node-type This command configures the NetBIOS node type for Microsoft DHCP clients. Use
the no form to remove the NetBIOS node type.
Syntax
netbios-node-type type
no netbios-node-type
type - Specifies the NetBIOS node type:
broadcast
hybrid (recommended)
mixed
peer-to-peer
Default Setting
None
Command Mode
DHCP Pool Configuration
Example
Console(config-dhcp)#netbios-node-type hybrid
Console(config-dhcp)#
Related Commands
netbios-name-server (900)
network This command configures the subnet number and mask for a DHCP address pool.
Use the no form to remove the subnet number and mask.
Syntax
network network-number [mask]
no network
network-number - The IP address of the DHCP address pool.
mask - The bit combination that identifies the network (or subnet) and the
host portion of the DHCP address pool.
Command Mode
DHCP Pool Configuration
Usage Guidelines
◆ When a client request is received, the switch first checks for a network address
pool matching the gateway where the request originated (i.e., if the request
was forwarded by a relay server). If there is no gateway in the client request (i.e.,
To Next Page
Loading...
