Edge-Core ECS4620-28F-2AC - Page 911

Chapter 30 | IP Interface Commands
IPv4 Interface
– 911 –
after the % delimiter. For example, FE80::7272%1 identifies VLAN 1 as the
interface.
Example
The following example defines a default gateway for this device:
Console(config)#ip default-gateway 192.168.0.1
Console(config)#end
Console#show ip route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default
S* 0.0.0.0/0 [1/0] via 192.168.0.1, VLAN1
C 192.168.0.0/24 is directly connected, VLAN1
Console(config)#
Related Commands
ip address (908)
ip route (976)
ipv6 default-gateway (924)
show ip interface This command displays the settings of an IPv4 interface.
Command Mode
Privileged Exec
Example
Console#show ip interface
VLAN 1 is Administrative Up - Link Up
Address is 00-E0-00-00-00-01
Index: 1001, MTU: 1500
Address Mode is DHCP
IP Address: 192.168.0.2 Mask: 255.255.255.0
Proxy ARP is disabled
DHCP Client Vendor Class ID (text): ECS4620-28F
DHCP Inform is disabled
DHCP relay server: 0.0.0.0
Console#
Related Commands
ip address (908)
show ipv6 interface (932)