VP3302 IP Phone User Manual
8. NET
uccessfully registered to their service provider, this
9.
is used
e “Dial
ed to
pper layer of the menu selection.
he IP phone is editing some menu item’s contents, this key is
NUM
W aracters, press this button and the alphabets
shown on the keypads will be displayed.
13.
T he
),
in
r the call to another party. If the call
transfer is successful, a busy tone will be heard to notify the user to hang up
When users are not s
button light will flash. Users can press this button to try to register again to
their service provider.
MESSAGE
This is for future use with functions upgrade.
10. MENU/OK
When the IP phone is in an idle state, this key is used as “Menu” to bring
out the menu selection on the LCD display.
When inside the menu selection/setting on the LCD display, this key
as the “OK” key to enter into a lower layer of menu selection or to accept
the edited item’s contents.
When the IP phone is in dial mode, the “OK/Menu” key is used as th
Out” key.
11. CANCEL
When the IP phone is entered into the menu selection, this key is us
escape to an u
And when t
used to cancel the current edit and escape to an upper layer of the menu
selection.
12. TXT ←→
hen users need to enter ch
TRANSFER
his key is pressed to transfer an active call to another IP phone. When t
IP phone is active (incoming call is answered or outgoing call is accepted
by pressing this key, a dial tone will be heard, then the user can key
another IP phone’s number to transfe
www.edge-core.com
11
To Next Page
Loading...