3
Water Requirements
Make sure to use a new water supply line when installing the dishwasher. Old water lines are
susceptible to leaks. Ensure the water supplied to the dishwasher does not freeze. Frozen water can
damage water lines, valves, pumps, and other components.
Water Pressure
For best results, incoming water pressure should be between 6 and 145 pounds per square
inch (psi).
Water Temperature
For best results, the water temperature must be at least 120ºF (49ºC). To prevent damage to
the dishwasher contents, the temperature of the incoming water supply should not exceed
149ºF (65ºC).
Electrical Requirements
Read all safety precautions listed at the beginning of this manual. It is recommended that you use
receptacles that cannot be turned off by a switch or pull chain.
The dishwasher must be supplied with 120V, 60Hz, and connected to an individual properly
grounded branch circuit, protected by 15 or 20 amp circuit breaker.
Wiring must be 2-wire with ground.
If the electrical supply does not meet the above requirements, call a licensed electrician
before proceeding.
Grounding Instructions – Cable Direct
This appliance must be connected to a grounded metal, permanent wiring system, or an equipment
grounding conductor must be run with the circuit conductors and be connected to the equipment
grounding terminal or lead on the appliance.
Caution:
Remove house fuse or turn off circuit breaker before beginning installation.
Improper connection of the equipment grounding conductor can result in risk of electric
shock.
Check with a qualified electrician if you are in doubt that the appliance is properly grounded.
Do not use an extension cord or an adapter plug with this appliance.
Caution:
For the water supply line it is strongly recommended to use copper tubing with a
compression fitting or a flexible, stainless steel braided line.
Do not use plastic tubing as it can deteriorate over time and leak.
To Next Page
Loading...
