15
Step 12: Complete the Installation
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Open the water supply valve to provide water to the dishwasher. Check for water leaks on
both ends of the water supply line and drain hose connector.
3. Turn on the circuit breaker to provide power to the dishwasher. Make sure dishwasher powers
on correctly and run a wash cycle. Continue checking for leaks and make sure the cycle runs
without any errors. If an error does occur turn off the dishwasher, close the water supply valve
and refer to the user manual or contact customer service.
4. If the dishwasher runs the wash cycle without error attach the kick plate with screws ST3.9*13.
To Next Page
Loading...
